Since everybody has an alternate size temple, the clasp on blasts are 6″ long. You should have them sliced to the length and shape you want.
Step 1:
Clip off the label so it doesn’t get in your direction or show when worn. Wet the whole piece and brush straight. Unsnap the brush by twisting up on the edges.
Back-brush (tease, rodent) your own particular the hair where the clasp will connect in the front blast range. Slide the clasp under the back-brushed hair and snap close by twisting the edges down. Extra bobbie pins or toupee tape might be utilized to secure piece in the event that it feels free. A great many people discover it stays great with simply the one clasp once the blasts are cut.
Step 2:
Make a point to cut the piece around 1 or 2 inches from the front hairline. The hair will be too long and hang into your face until it is trimmed the right length.
Oppose the allurement to clasp it back more distant so as to “abbreviate” the blasts. This is inaccurate and will make the blasts look meager and inadequate.
Step 3:
Freely hold hair and trim hair to length fancied. Try not to draw them down tight or they will be shorter than you need them when they bob go down. Likewise, wet blasts will contract when dry, so abandon them longer than you might suspect they ought to be.
On the off chance that you are uncertain, have them cut by an expert beautician.
Step 4:
Fan out and style as you would your own blasts. Since the pieces are human hair, twisting or level irons, rollers, blow dryer, hair shower, and so on might be utilized.
When they are sliced to sought length, they are anything but difficult to reuse, again and again. It just takes a few moments to clasp them on and off.